SONIC ART REGA VTA THREADED MOUNT

$200.00

Add to Cart:

Sonic Art REGA THREADED VTA MOUNT

We are proud to present our custom machined VTA mounting system for the Rega RB220/330 series of arm and all OEM versions. Designed to drop into a 23mm hole exactly like the original RB250/300 series! Avoid having to drill holes into your solid plinth or armboard, and enjoy the benefit of easily adjustable VTA for your Rega arm. This mount requires more extensive modification of the arm with the removal of the plastic tube below the bearing assembly which means the internal wiring must be replaced due to being too short to reach the end plug. Your original Rega external wiring loom will fit straight into the base of the VTA mount or you can order our external wiring upgrade to go with the VTA.

At present we are suggesting customers send their arm in to be modified and rebuilt, we are charging a token amount of AUD$60.00 to replace the internal wiring with Cardas litz tonearm wire and cut away the plastic base tube of your arm.

The Sonic Art VTA raises your arm approximately 6mm from standard as a minimum new height, and you can adjust the VTA with the rotating ring to raise the arm 10-20mm higher (depending on arm board thickness). The 23mm threaded shaft is 45mm long, we machine a solid alloy nut to secure the new mount to your deck/armboard. We can make the threaded shaft shorter if you have a thin arm board and require good clearance below the board, simply discuss your needs with us before ordering.

PHOTO SHOWS SA330 WITH THE SONIC ART VTA MOUNT INSTALLED

 

NOTE: VTA is custom machined to order, please allow 3-5 days for your order to be completed and installed to your arm.

 

 


This product was added to our catalog on Monday 21 September, 2020.

  • 1 Units in Stock
Your IP Address is: 3.219.31.204
Copyright © 2020 Sonic Art AUSTRALIA. Powered by Zen Cart